Manual Transmission
Showing all 10 results
 | 1967-72 Chevy-GMC C/K Clutch rod boot. Attaches to firewall and used to seal opening for clutch rod where it passes through firewall to prevent heat, moisture and debris from entering cab. Replaces GM Part #6264123 | $9.00 Max: 2 Min: 1 Step: 1 View Product |
 | 1968-72 4spd rubber floor shifter boot. 4 speed floor shifter boot, specify if 1968-72 Small Block V-8 2 wheel drive or 1968-72 4 wheel drive. NOTE: A limited number of models were equipped with a SM435 transmission which is a 4 speed close ratio transmission. The shifter boot for these models is rectangular and is… | $25.00 Max: 4 Min: 1 Step: 1 View Product |
 | Models With 4 Wheel Drive Only | $16.00 Max: 2 Min: 1 Step: 1 View Product |
 | 1967-72 Transfer Case Rubber Floor Shifter Boot. Reproduction of the 1971-72 version. This can be used on earlier 1967-70 models but not correct style as the appearance does differ. | $24.50 Max: 2 Min: 1 Step: 1 View Product |
 | 1967-70 4×4 transfer case lever shifter knob, original style knob with 3/8 24 fine thread. These do not have the shift pattern on them. | $24.00 Max: Min: 1 Step: 1 View Product |
 | 1967-72 High hump transmission cover. Removable high hump transmission cover used on 1967-72 truck, Suburban, 69-72 Blazer, Jimmy and 67-70 Panel truck. Used on all 4 wheel drives and big block 2 wheel drives. Exactly like original in every detail fit, form and 16 gauge steel construction. Due to the many configurations of transmissions used… | $130.00 Max: Min: 1 Step: 1 View Product |
 | 1947-72 Chevy-GMC speedometer cable. Steel sheathed cable that’s vinyl wrapped to prevent corrosion which results in a sticky speedometer cable. | $18.00 Max: Min: 1 Step: 1 View Product |
 | 1960-72 Chevy-GMC C/K Clutch fork boot. Attaches to bell housing and used to seal bell housing to clutch fork to prevent moisture and debris from entering it and damaging clutch disc and flywheel and pressure plate. 4 1/4″ long by 2 1/4″ wide, and 2 1/8″ high with 3/4″ x 1″ clutch fork arm hole.… | $9.50 Max: Min: 0 Step: 1 View Product |
 | 1960-75 Transfer Case Torque Mounting Grommets. The kit includes 2-Upper and 2-Lower cushions made from polyurethane. Requires 2 kits per truck. | $24.00 Max: Min: 0 Step: 1 View Product |
 | 1955-72 Carrier Bearing for 1/2 and 3/4 ton 2 wheel drive. Heavy Duty 1/2-3/4ton Version= Side to side mount, or standard 1/2ton= front to rear mount. Select side to side for leaf spring trucks or front to rear style for coil spring trucks. | $28.95 Max: Min: 1 Step: 1 View Product |